• Live programming – Enables programming changes to be made
at any time—
even during watering!
• Fully automatic, semi-automatic and manual station operations.
• Manual Advance – Enables quick manual advance up through
the station sequence. Works in all Automatic, Semi-auto and
Manual operations.
• Off or Stop – Immediately stops and prevents all watering activity
without disturbing Programs.
• Four places available to quickly remove start times – Enables
Start Times to be turned Off between 11:59 PM/12:00 AM,
11:59 AM/12:00 PM, 5:59 AM/ 6:00 AM and 5:59 PM/ 6:00 PM
• Rain Delay – Enables automatic watering to be postponed from
1 to 9 days, then automatically resume scheduled watering.
• Water Budget – Enables the run time of all stations within a
Program to be scaled up or down from 0 to 200%.
• MV/Pump On/Off per station – Enables activation of the Master
Valve/Pump circuit to be controlled by individual stations.
• Timed delay between stations – Enables a timed delay period
to occur between stations in sequence to compensate for slow-
closing valves and/or well recovery time.
• Pump On/Off during timed delay – For systems using a pres-
sure pump, slow-closing valves would require the pump to be
active during a delay between stations; a well-water recovery
system may not—
Rain Dial provides the choice!
• Built-in circuit protection – Helps protect Rain Dial’s electronic
components from damage due to power surges.
• Diagnostic Circuit Breaker – Enables the controller to detect and
bypass any station with a short circuit or faulty solenoid. Displays
“FUS” and the bypassed station number for easy troubleshooting.
• Clear Program Memory – Enables individual Program memory
to be cleared without affecting other Programs.
• Reset to Factory Program Defaults – Enables factory default
operating parameters to be easily restored if needed.
3
66767_RainDial 0428A 3/28/07 2:24 PM Page 3
To Next Page
Loading...
Need help?
General
