Doc. SIE10166 Rev. 10 Page 13 of 28
3 OPTIONS
Options 1 to 4 are to be specified at order, even if it is possible to install them later on.
3.1 STATIC AND DYNAMIC RESISTANCE MEASUREMENT, CODE PII23166.
The option performances are described at paragraphs 2.8 and 2.9. Physically, it is made of a printed
circuit board, to be mounted on the mother panel, and of a capacitor, to be mounted on the base.
Even if it is possible to upgrade CBA1000, it is advisable to request the option at order: see below
for the CBA1000 coding. In case of an order after CBA1000 delivery, use the code in the title.
3.2 FOUR COIL COMMANDS, CODE PII43166.
With this option the test set is provided with the circuits to drive four coils (three Open, one Close),
rather than two. The option is made of an additional printed circuit board that fits into the mother
board.
Even if it is possible to upgrade CBA1000, it is advisable to request the option at order: see below
for the CBA1000 coding. In case of an order after CBA1000 delivery, use the code in the title.
3.3 INTERNAL PRINTER, CODE PII33166.
CBA1000 can be provided with a built-in thermal printer. Printer characteristics:
- Type: thermal;
- Paper width: 58 mm;
- Recordings: the selected window.
This option is exclusive of the DC loss test.
Even if it is possible to upgrade CBA1000, it is advisable to request the option at order: see below
for the CBA1000 coding. In case of an order after CBA1000 delivery, use the code in the title.
3.4 EXTERNAL PRINTER, CODE PII14102.
Thermal printer, for the printout of all test results. Paper 112 mm wide.
3.5 MINIMUM TRIP COIL TEST.
These options have the purpose of allowing to test the behaviour of the Minimum Trip Coil circuit
and of Open or Close coils, when supplied at a reduced voltage.
There are two modules available: one, code PII34166, is for battery voltages up to 250 V; the other
one, code PII24166, is for battery voltages up to 70 V.
The option is to be connected to the auxiliary DC supply of the plant; the option output voltage can
be modified (stepped or ramped down), according to the test program.
This option is exclusive of the internal printer.
Even if it is possible to upgrade CBA1000, it is advisable to request the option at order: see below
for the CBA1000 coding. In case of an order after CBA1000 delivery, use the code above.
Options characteristics:
Shop for Power Metering products online at:
1.877.766.5412
www.PowerMeterStore.ca
To Next Page
Loading...
