How much battery level is left is shown on the display. Make sure the
battery level is full before heading out on a long distance ride.
Tire wear and tear is normal. The rate at which the tires deteriorate
depends on riding style i.e. casual riding may yield minimal wear while
performance and/or heavy riding may yield excessive wear. To
purchase tire replacements and/or for questions about your scooter’s
parts, please visit our website.
Step 1. Press the power switch to turn on the power. Carefully step on the
deck with one foot and stand upright but relaxed. Grab both handlebars.
Step 2. Keep the other foot on the ground and kick off to begin accelerating
manually.
Step 3. Ride forward by pushing the throttle and use the handlebars to steer.
Step 4. To stop, release the throttle and use the thumb brake, foot brake, or
both to gradually coast to a stop then step off the scooter one foot at a time.
Be extra cautious when dismounting for the first time.
Step 5. To turn the power off, press and hold the power button for 3-5 sec
after a complete stop for a few seconds.
For your own safety, please carefully read this entire section before a
ride.
Do not perform any maintenance when the power is on, or the battery
is charging.
Before riding, wear suitable protective gear and make sure the fully charged
iscooter i8 has been placed on a level surface and there is no issue with the
scooter, then follow the steps below. For your safety, please read this entire
section before attempting to ride.
After each ride, especially if you have traveled a long distance, inspect your
scooter.
■Inspect the brakes to make sure they are working properly.
■Make sure all screws and bolts are properly fastened to prevent injury and
unnecessary wear and tear.
5.1 How to Ride
1010
MAINTENANCE
To Next Page
Loading...
