Document history
Version Date Major changes
1.0 29.1.2016 Initial release
1.1 29.1.2016 Corrected item codes
1.2 19.4.2016 Text and format revisions, Safety-Loop text changes
1.3 03.8.2016 Add Appendix
1.4 07.04.2017 ICS2.1 update
Disclaimer / Copyright
Copyright © 2015-2017 iseg Spezialelektronik GmbH / Germany. All Rights Reserved.
This document is under copyright of iseg Spezialelektronik GmbH, Germany. It is forbitten to copy, extract parts, duplicate for any
kind of publication without a written permission of iseg Spezialelektronik GmbH. This information has been prepared for assisting
operation and maintenance personnel to enable efficient use.
Important security information
Please read all security warnings and notices carefully. iseg declines responsibility for any kind of damage, injuries or other
consequences that are caused by improper use or negligence, whether or not under conditional intent.
WARNING advices in text indicate attention to hazards, that could lead to injuries or death.
CAUTION notes in text indicate information to avoid damages to the equipment.
INFO notes in text show important information and resources.
SAFETY ADVICE
WARNING
This device generates high voltages or is part of or attached to high voltage supplying systems.
High voltages are dangerous and may be fatal.
USE CAUTION WHILE WORKING WITH THIS EQUIPMENT.
BE AWARE OF ELECTRICAL HAZARDS.
Always follow at the minimum these provisions:
• High voltages must always be grounded
• Do not touch wiring or connectors without securing
• Never remove covers or equipment
• Always observe humidity conditions
• Service must be done by qualified personnel only
WARNING
WARNING
RAMP DOWN VOLTAGES !
Before insertion or removal of crate controller, please make sure, that all voltages are ramped down, crates are
switched off and power cord is disconnected.
ATTENTION
CAUTION
CHECK COMPATIBILITY
Please use this device only in compatible MMS crates. Check compatibility list first.
To Next Page
Loading...
Need help?
General
