5
ILCM 06 English
In AUTOHOLD mode, if the measured value remains
within ±10 counts over 10 measuring cycles the
instrument will beep 4 times, the measured value
will be held on the display and "AUTOHOLD" will
be displayed.
Subsequently if the measured value changes by ±10
counts, the instrument will beep, "AUTOHOLD" will
disappear and the instrument will revert to displaying
the new readings until the next AUTOHOLD conditions
are met.
Note: When AUTOHOLD activates, the displayed
reading will be held for 3 seconds if the clamp jaws are
removed from the cable. During this time the HOLD
key can be pressed to hold the reading indenitely.
Press < 3sec
at power on
Press > 3sec
at power on
To Next Page
Loading...
