IPS X303 Series Instruction Manual
6
Safety Guidelines
General
Guidelines
CAUTION
Do not place any heavy object on the IPS X303 series.
Avoid severe impacts or rough handling that leads to damaging the
IPS X303 series.
Do not discharge static electricity to the IPS X303 series.
Do not block or obstruct the cooling fan vent opening.
Do not perform measurement at circuits directly connected to Mains
(see note below).
Do not disassemble the IPS X303 series unless you are qualified as
service personnel.
(Measurement categories) EN 61010-1:2001 specifies the measurement
categories and their requirements as follows. The IPS X303 series falls
under category I.
Measurement category IV is for measurement performed at the
source of low-voltage installation.
Measurement category III is for measurement performed in the
building installation.
Measurement category II is for measurement performed on the
circuits directly connected to the low voltage installation.
Measurement category I is for measurements performed on circuits
not directly connected to Mains.
AC Input voltage: 100V/120V/220V/230V ±10%, 50/60Hz
Connect the protective grounding conductor of the AC power cord to
an earth ground, to avoid electrical shock.
Fuse type: 100V/120V: T6.3A/250V, 220V/230V: T3.15A/250V
Make sure the correct type of fuse is installed before power up.
To ensure fire protection, replace the fuse only with the specified type
and rating.
Disconnect the power cord before fuse replacement.
Make sure the cause of fuse blowout is fixed before fuse replacement.
Cleaning the IPS
X303 series
Disconnect the power cord before cleaning.
Use a soft cloth dampened in a solution of mild detergent and water.
Do not spray any liquid.
Do not use chemicals or cleaners containing harsh products such as
benzene, toluene, xylene, and acetone.
To Next Page
Loading...
Need help?
General
