How to reduce noise so neighbors don't hear ISOVOX 2?
To prevent neighbors from hearing you through your ISOVOX Recording Equipment, ensure the unit is height adjusted properly, allowing some shoulder room but not excessively. If you have thin walls, position the ISOVOX 2 as far from your closest neighbor as possible.
What to do if my ISOVOX 2 unit seems unstable?
To stabilize your ISOVOX Recording Equipment unit, check the floor stand setup, referring to the manufacturer's manual, and ensure the feet are fully extended. Verify the base plate is mounted correctly, consulting the product installation guide. If the height exceeds 178 cm (70 in) or the tripod feet aren't extended to their minimum 60 cm (24 in) radius, lower the height.
How to fix a stuck zipper on ISOVOX 2?
If the zipper on your ISOVOX Recording Equipment is stuck, first, carefully try to reconnect the zippers. Second, check for any material caught between the zippers; if found, gently pull the zipper while extracting the material. Third, check if another zipper handle is stuck; if so, drag down the zipper and use your finger to dislodge the stuck handle.
What to do if Flex-Mount of ISOVOX Recording Equipment doesn't fit my microphone?
If the included Flex-Mount doesn't fit your microphone, carefully squeeze the arms of the Flex Mount 2 onto the body of your microphone. It will flex and adapt to the diameter of your microphone. If the microphone falls out because it is too small or too big, use your own shock mount or buy an OnStage MY330.
Why doesn't my microphone fit in my ISOVOX 2 Recording Equipment?
If your microphone doesn't fit in the ISOVOX Recording Equipment, first check if it's a supported studio condenser mic with your dealer. Note that the ISOVOX 2 is not designed for dynamic microphones. Also, remove any 3/8” adapter from the microphone's mounting hole to fit the internal mic pole.
How to mount my own shock mount on ISOVOX Recording Equipment?
To mount your own shock mount on the ISOVOX Recording Equipment, hold the 5/8” fitting over the Mic Pole (Part B) and screw the Mic Pole onto the Shock Mount. Also, remove the 3/8” adapter from the mounting hole so it will fit the internal mic pole.
What to do if the OSRAM LED-STIXX Lamp is not working in my ISOVOX 2 Recording Equipment?
To address an OSRAM LED-STIXX Lamp not working with your ISOVOX Recording Equipment, unscrew the white end opposite the on/off switch, pull out the battery holder, replace the AAA batteries, and recycle the old ones, keeping them away from children. Consult the OSRAM manual for details.
Clarifies the meaning of DANGER, WARNING, and CAUTION safety alert levels.
Specifies intended applications for vocal practice/recording and lists prohibited uses.
Comprehensive guide to assembling and setting up the ISOVOX 2 unit.
Step-by-step assembly instructions, including component attachment, zipping, stand mounting, and accessory setup.
General instructions for operating the ISOVOX 2 for vocal practice and recording.
Steps to follow if experiencing dizziness or breathing difficulties while using the product.
Addresses common issues like stuck zippers, microphone fitting, and stand stability with solutions.
General| Brand | ISOVOX |
|---|---|
| Model | 2 |
| Category | Recording Equipment |
| Language | English |
To Next Page