4.1.2 Installation of the product
To install the product:
1. Place the base plate
Ⓓ with the metal
thread hole away from you.
2. Attach the left side
Ⓑ and right side Ⓒ to the base plate Ⓓ.
2cm/0,8in
The edge of the base plate Ⓓ should be in line with the edge of the Velcro fastener on
the left side
Ⓑ and right side Ⓒ. This way you will get enough material that can bend
over the wooden edge. Failure to do this may result in damage to the product and is not
covered by warranty.
To Next Page
Loading...