6 MAINTENANCE
6.1 HOW TO CLEAN THE PRODUCT
To clean the product:
1. Use a vacuum cleaner on the lowest possible suction grade to remove dust. Do not
vacuum near the logo or the LED lamp.
2. Use a cloth dampened with a mild detergent solution or lukewarm water to remove
stains on the outer shell.
NOTICE!
Do not use alcohols (e.g. spirits) or chemical
cleansers and solvents as these can damage the surface and components.
3. To remove stains on the fabric interior, use hot water and a well bound cloth like
Wettex kitchen or similar. Rub carefully against the material, without soaking the
interior.
6.2 HOW TO REPLACE THE BATTERIES
Beware that there is a risk of explosion if replacing the batteries with an incorrect type.
Use only AAA batteries from OSRAM (model LED-Stixx).
To replace the batteries:
1. Unscrew the end at the opposite side of the on/off switch.
2. Pull out the battery holder.
3. Replace the batteries.
4. Dispose of used batteries according to the instructions. See Disposal.
Keep used batteries away from children. RISK OF EXPLOSION! Beware that there is
a risk of explosion if replacing the batteries with an incorrect type. Handle the used
batteries according to the manufacturer’s instructions.
To Next Page
Loading...