7 TROUBLESHOOTING AND REPAIR
7.1 HOW TO IDENTIFY AND SOLVE PROBLEMS
Error Cause Solution
Zipper is stuck 1. Zipper is not attached
properly.
2. Material is stuck between
the zippers.
3. Another zipper handle
may be stuck between the
zippers.
1. Try to reconnect the zippers
carefully.
2. See if there is any material stuck
between the zippers. If so, carefully
pull on the zipper while pulling out
the material.
3. Drag down the zipper, use your
nger to push away the zipper
handle that may have gotten stuck.
Microphone does
not t
1. Microphone is not a studio
condenser mic.
2. Microphone is a dynamic
mic that needs to be mounted
horizontally.
3. Microphone has the 3/8”
adaptor in the mounting hole.
1. Please check with your dealer if
your mic is supported.
2. ISOVOX 2 is not designed for
use with dynamic microphones.
3. Remove the 3/8” adaptor (this
is often golden). After you have
removed this, it will t the internal
mic pole of ISOVOX 2.
Can't mount my
own shock mount
1. You have tried the wrong
method.
2. It has the 3/8” adaptor in
the mounting hole.
1. Hold the 5/8” tting over the
Mic Pole (Part B), and screw the
Mic Pole onto the Shock Mount.
2. Remove the 3/8” adaptor (often
this is golden). After you have
removed this, it will t the internal
mic pole of ISOVOX 2.
Adjust the height
of the stand
See the instructions that came
from the manufacturer of the
stand.
To Next Page