OSRAM LED-STIXX
Lamp not working
1. AAA batteries need to be
changed.
1. Unscrew the white end at the
opposite side of the on/off switch.
Pull out the battery holder in the
same direction as the on/off switch.
Replace the batteries. Make sure to
recycle your old batteries, and keep
them away from children. See the
included manual from OSRAM for
further details.
Neighbors
hearing me
1. The unit is not height
adjusted properly.
2. You have unusually thin
walls.
1. Adjust the height so that there is
some room for your shoulders, but
not too much.
2. Place the ISOVOX 2 as far as
possible from your closest neighbor.
The unit seems
unstable and may
fall
1. The oor stand is not set
up properly.
2. You have mounted the
base plate
in the wrong
direction.
3. You have set the height
over the acceptable and
recommended limit =
178 cm (70 in) and/or not
extended the tripod feet to
their minimum. The required
radius is 60 cm (24 in).
1. See the oor-stand manual
supplied by the manufacturer.
Usually when it’s unstable, it’s
because the feet are not fully
extended.
2. Check if you have mounted the
base plate
Ⓓ in the right direction.
See Installation of the product.
3. Lower the height to stabilize.
The included Flex-
Mount does not t
my microphone
1. You have not squeezed
enough.
2. My microphone falls out of
the arms of the Flex Mount 2.
1. Carefully squeeze the arms of the
Flex Mount 2 onto the body of your
microphone. It will ex and adapt to
the diameter of your microphone.
2. If the microphone falls out of the
Flex Mount then it is too small or
too big. Please use your own shock
mount instead or buy an OnStage
MY330, which will usually work
well with larger microphones.
I'm missing a part
Contact us at info@isovoxbooth.com
To Next Page
Loading...