Ispring RO600 Series User Manual

Malfunction Inspection
Malfunction
Possible Issue
Possible solution
Leakage in
connections
1. PE pipe is cracked.
2. PE pipe is not inserted properly into
the port.
3. The tubing end tip is not cut well.
1. Replace the pipe.
2. Reinsert the pipe about 1/2'' into the
port.
3. Make clean cuts on the tubing.
The filter is not installed correctly.
Correctly assemble the filter.
The feed water adapter is not installed
correctly.
Correctly assemble the feed water
adapter.
No display on
the control
panel
The system is not connected to power. Check the power.
Automatic
shutdown
The booster pump is overworking.
Unplug and plug in the booster pump.
The booster pump turns on and off
frequently.
Close the inlet valve and verify there is
no leakage in the system. Unplug and
plug in the booster pump.
www.123filter.com | (678) 261-7611 | support@123filter.com Page 15

Ispring RO600 Series Specifications

General

Brand	Ispring
Model	RO600 Series
Category	Water Filtration Systems
Language	English