B. Insert the filters with the handles pointed toward the "unlocked" sign. Swirl the handles
clockwise and align the arrow with the mark on the side of the slot until they reach the end.
The filters should fit snugly into the system's fittings. Swirl the handles counterclockwise
until they reach the end and pull them out to remove the filters.
5) System Installation and Setup
Precautions:
• Make clean cuts on the tube to ensure a tight, sealed connection.
• Insert each pipe about 1/2'' into the port to prevent leaks.
• Always use the C-clips to secure the quick-fitting connections.
• After assembly, check to ensure the connection is not leaking.
Inlet Water Pipeline Installation:
A. Cut the WHITE 3/8" PE pipe, which is connected to the feed water adapter, to the
appropriate length using a utility knife.
B. Insert the other end of the WHITE tube into the 3/8" port marked "Inlet" at the top of the
system. Secure the connection by inserting the enclosed 3/8" C-clip.
www.123filter.com | (678) 261-7611 | support@123filter.com Page 9
To Next Page
Loading...
Need help?
General
