- 9 -
Step 2 - Plug both ends of the lamp into the power sockets with the green wires.
1) Plug one end of the lamp into the
small power socket with the green
wires.
2) Plug the other end of the green
wires into the big power socket of
the lamp holder
3) Plug the other end of the lamp
into the same big power socket of
the lamp holder
Step 3 - Insert the lamp into the pre-installed quartz sleeve and install the black rubber cap.
1) Insert the lamp into the pre-
installed quartz sleeve.
2) Attach the black rubber cap to
the end.
3) Snap the housing onto the clips
To Next Page
Loading...
