Finish the master assembly by attaching the outer face plate and tightening the 3 screws
on the bottom of the face plate.
Important Note:
On the back of the master, the green station connectors are numbered from 1 to 13. Connectors 1
through 9 are for room stations only. Connectors 10, 11, 12 and 13 can be used for either a room
station or a patio station. But for proper operation when using these 4 ports, you must select
either room or patio on switch SW1-4 located on the back of the main printed circuit board.
Intrasonic Technology, Inc. l 610 presidential Dr. Suite 104 l Richardson, Texas 75081 877-435-0670
Page 10 of 18
To Next Page
Loading...