10. Changing the Admin PIN
You can change the Admin PIN by doing the following:
1. Enter Admin Mode (refer to page 9 for details).
2. Press and hold + 9 until the LED indicator light flashes BLUE.
3. Enter the new PIN and press (The PIN must be a minimum
of 6 digits and a maximum of 16 digits). The LED indicator light flashes
GREEN three times. See note below.
4. Re-enter the new Admin PIN and press . The LED indicator light
will be solid GREEN for two seconds and then the LED indicator light
will become solid BLUE indicating that the Admin PIN has been changed
successfully.
Note: If the LED indicator light flashes RED three times, this indicates that the PIN is less than 6 digits
or more than 16 digits. Enter a PIN that contains 6 – 16 digits after the LED indicator light flashes
BLUE intermittently.
1. If the LED indicator light flashes RED intermittently and then BLUE intermittently, go back
to step 3. This is due to one of the following conditions:
• You waited longer than 10 seconds before entering a PIN.
• The new PIN was entered incorrectly.
2. If no activity is detected within two minutes in the Admin Mode, the
diskAshur DT will return to the Standby Mode.
To Next Page
Loading...
Need help?
General