5. Entering the Standby Mode
The Standby Mode is the default mode of the diskAshur DT and is the gateway to other operations.
To enter the Standby Mode, attach the diskAshur DT to your computer. The drive automatically goes into Standby Mode and
the LED indicator light turns RED. In this mode, the diskAshur DT is locked. It cannot be recognized by My Computer and it
does not provide either the regular functions or the encryption function. However, it enables you to enter and switch between
the Admin Mode and the User Mode.
Attention: To switch between the Admin Mode and the User Mode, you are required to switch to the
Standby Mode first, and then you can enter the mode of your choice.
6. Entering the User Mode
To enter the User Mode, do the following:
1. Attach the drive to your computer and to a power outlet using the AC Adapter.
Turn the power switch to the ON position. The drive will be in Standby Mode.
2. Enter the User PIN or the Admin PIN (the default Admin PIN is 123456) and
press . The LED indicator light turns GREEN indicating that the drive is in
the User Mode. If the LED indicator light flashes RED, you need to re-enter the
correct PIN.
7. Exiting the User Mode
To exit the User Mode, press the “Cancel” button on the diskAshur DT keypad. If there is no activity for 5 seconds the drive
will lock and go into Standby mode.
Alternately, you can turn your diskAshur DT OFF at the power switch on the back of the unit. Once you turn the diskAshur DT
ON again, the LED indicator light will be RED, indicating that you are in the Standby Mode.
To Next Page
Loading...
Need help?
General