Isuzu 22LE - Operations on Crank Drive; Con-Rod Bearing; Piston with Con-Rod

ENGINE MECHANICAL (C22NE, 22LE, 20LE) 6A-53
OPERATIONS ON CRANK DRIVE
Con-Rod Bearing
Removal
1. Remove oil pan according to the corresponding
operation.
2. Remove con-rod bearing cap and con-rod bearing after
marking both sides.
Clean
Con-rod journal, con-rod bearing cap
Installation
1. Install new bearing shafts lightly coated with engine oil.
2. Install con-rod bearing cap.
Torque-Angle Method
Con-rod bearing cap to con-rod - 35N⋅m (3.5 kgf⋅m) +45° to
60°
Important!
Use new bolts.
3. Install oil pan according to the corresponding operation.
Piston with Con-Rod
Removal
1. Remove cylinder head and oil pan according to the
corresponding operations.
2. Remove piston with con-rod after marking con-rod
bearing cap.
Inspection
Remove and install all parts, if applicable.
Important!
Ring gap offset:
Piston rings - 180°.
Oil scraper rings - 25 to 50 mm/1 to 2 in. from gap of
intermediate ring to the left and to the right.