ENGINE ASSEMBLY ( 3 )
101
5. Timing Case Cover
1) Before installing the timing gear case, apply a 3
mm x 5 mm (0.12 in x 0.20 in) strip of liquid
gasket to the portion of the feather key indicated
by the arrow in the illustration.
2) Check that the timing case cover O-ring is firmly
inserted into the gear case groove.
3) Tighten the timing case cover bolts to the speci-
fied torque.
Timing Case Cover Bolt Torque kgf·m(lb.ft/N·m)
M 8x1.25 (0.31x0.05)
1.4 – 2.4 (10.1 – 17.3/13.7 – 23.5)
Bolt
M12x1.25 (0.47x0.05)
6.7 – 8.7 (48.5 – 62.9/65.7 – 85.3)
Bolt
7. Crankshaft Damper Pulley with Dust Seal
1) Block the flywheel ring gear with a piece of
wood to prevent it from turning.
2) Tighten the crankshaft damper pulley to the
specified torque.
Crankshaft Damper Pulley Bolt
Torque kgf·m(lb.ft/N·m)
17.0 – 21.0(123.0 – 151.9/166.7 – 205.9)
Take care not to damage the crankshaft damper
pulley boss.
8. Cylinder Head Gasket
The cylinder gasket “TOP” mark must be facing up.
To Next Page
Loading...
