Need help?Do you have a question about the ITech IT6018C-1500-40 and is the answer not in the manual?
General| Model | IT6018C-1500-40 |
|---|---|
| Category | Power Supply |
| Output Power | 1500 W |
| Output Voltage | 0-40 V |
| Output Current | 0-37.5 A |
| Current Resolution | 1mA |
| Input Voltage | 100-240 VAC |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -20°C to 70°C |
| Current Accuracy | 0.1% + 10 mA |
| Input Frequency | 50Hz/60Hz |
| Ripple and Noise (CC) | ≤20mArms |
Defines CAUTION, WARNING, and NOTE symbols used in the manual.
Details ITECH's warranty terms and conditions for the product.
Outlines conditions under which the warranty becomes invalid.
Lists essential safety precautions to be observed during instrument operation.
Provides an overview of how to navigate and operate the instrument's configuration menu.
Introduces the system menu items for understanding instrument functions and settings.
Explains how to safely connect the instrument to the power source, including precautions.
Describes how to connect the instrument to the device being tested, with safety precautions.
Details the methods for connecting the instrument to a computer for remote control.
Explains how to connect and configure the instrument using the USB interface.
Guides users on connecting the instrument to a LAN for network communication.
Guides users on setting the output voltage level for the power supply.
Explains how to navigate and use the instrument's front panel menu system for configuration.
Instructions for setting the desired output voltage level for the power supply.
Instructions for setting the desired output current level for the power supply.
Instructions for setting the desired output power level for the power supply.
Explains the configurable settings available within the power supply's configuration menu.
Details how to set the Constant Current (CC) or Constant Voltage (CV) priority mode for output control.
Overview of the various protection functions available to safeguard the instrument and connected devices.
Details settings for overvoltage protection, including limit and delay.
Details settings for overcurrent protection, including limit and delay.
Details settings for overpower protection, including limit and delay.
Details settings for undercurrent protection, including warm-up, limit, and delay.
Details settings for undervoltage protection, including warm-up, limit, and delay.
Explains the over-temperature protection mechanism and possible causes.
Overview of the various function menus available on the power supply.
Guides on simulating solar photovoltaic curves using MPPT for testing PV systems.
Details how to simulate battery characteristics for charge/discharge testing and analysis.
Details how to configure and use the data logging feature to record test data.
Explains how to configure the instrument for single or parallel operation modes.
Details the digital I/O functions for logic control and external signal interaction.
Presents the primary technical specifications of the power supply units.
Provides information on common faults and their solutions for the instrument series.
To Next Page