This command is used to read the standard event register
Query syntax：*ESE？
Parameter: None
Returned parameter：<NR1>
*ESR?
This command can read the value of standard event status register. After executing this
command, standard event status register is reset. Bit definition of standard event status
register is as the same as the standard event status enable register
Query syntax：*ESR？
Parameter: None
Returned parameter：<NR1>
*IDN?
This command can read information about power supply. The returns parameter contains 4
segments divided by comma.
Query syntax：*IDN？
Parameter: None
Returned parameter：<AARD> segment description
ITECH Ltd Manufacturer
6512 Product model
XXXXXX Product serial number
VX．XX –VX．XX Software version
Example：ITECH，6512，00000000000004，V1.01-V1.00
*OPC
When all commands before this command are executed, bit OPC in standard event register
will be set to 1.
Command syntax：*OPC
Parameter: None
Query syntax：*OPC？
Returned parameter：<NR1>
To Next Page
Loading...
