*RST
This command reset the power supply to default settings.
OUTP OFF CURR MIN
VOLT:PROT MAX VOLT MIN
Command syntax：*RST>
Parameter: None
*SRE
This command can set the parameter of state byte enable register. Setting parameter can
determine which byte value of state byte register is 1 and the byte will set RQS of state byte
register to 1. Bit definition of state byte enable register is as the same as the state byte
register.
Command syntax：*SRE <NR1>
Parameter:0~255
Query syntax：*SRE？
Returned parameter：<NR1>
*STB?
This command can read the data from status byte register.
Query syntax：*STB？
Parameter: None
Returned parameter：<NR1>
*TRG
When power supply trigger source is a command from via BUS, this command will give a
trigger signal. And its function is the same as “TRIGger” command.
Query syntax：*TRG
Parameter: None
Returned parameter：None
*SAV
This command can save the current setups of power supply to specified memory. These
setups contains current setups, voltage setups, max voltage set, min voltage set, OVP set,
OVP timer, OPP set, voltage rise and fall time, analog interface and series and parallel set.
The memory can divided into 10 groups, each contains 0~9 setups. So IT6512 can save 100
Setups in all.
To Next Page
Loading...
Need help?
General
