Series IT6700 User’s Manual
Copyright © Itech Electronic Co., Ltd. iii
⚫ If the equipment is not used in the manner specified by the manufacturer,
its protection may be damaged.
⚫ Always use dry cloth to clean the equipment housing. Do not clean the
inside of the instrument.
⚫ Do not block the air vent of the equipment.
Environmental conditions
The IT6700 series power supply can only be used indoors or in low
condensation areas. The following table shows general environmental
requirements for this instrument.
20% - 80% (non condensing)
Operating up to 2,000 meters
NOTE
In order to ensure the accuracy of measurement, it is recommended to operate the
instrument half an hour after start-up.
Regulation tag
The CE tag shows that the product complies with the
provisions of all relevant European laws (if the year is
shown, it indicates that the year when the design is
approved).
The UKCA tag shows that the product complies with the
provisions of all relevant United Kingdom laws (if the year
is shown, it indicates that the year when the design is
approved).
This instrument complies with the WEEE directive
(2002/96/EC) tag requirements. This attached product
tag shows that the electrical/electronic product cannot be
discarded in household waste.
This symbol indicates that no danger will happen or
toxic substances will not leak or cause damage in
normal use within the specified period. The service life
of the product is 10 years. The product can be used
safely within the environmental protection period;
otherwise, the product should be put into the recycling
system.
To Next Page
Loading...
