ITech IT6922A - Setting Maximum Output Voltage Limit

Function and Features
Copyright ©ITECH Electronics Co., Ltd. 18
ADC SPEED
SLOW
AD speed is low speed
MID
AD speed is middle speed
FAST
AD speed is high speed
TIMER SET
OFF
Close the timer function
ON
Open the timer operation, the time can be set within
0.1-99999.9s
RESET
NO
keep the original setting
YES
restore the factory setting
EXIT
Quit the menu setting
LIST SET
LIST STATE
OFF
Close list test function
ON
Open list test function
LIST LOAD
Recall the saved list file（FILE0-FILE9）
LIST EDIT
TIME
(SEC)
SEC
second
MIN
minute
VSET
Setup the single step voltage
ISET
Setup the single step current
SEC
Setup single step delay time(0.1-9999)
NEXT
(YES)
YES
continue the edit of next step
NO
End up the list file edit
REPET
1-65535
Set the cycle time of list file
SAVE
NO
Unsave the current list file
FILE0-FILE9
Save the list file to appointed document
EXIT
quit the system menu
POWER
INFO
MODEL
unit model
VER
the software version
SN-1
the first six number of SN
SN-2
the middle six number of SN
SN-3
the last six number of SN
EXIT
Quit the information menu
EXIT MENU
Quit the main menu
NOTE
Pressing
ESC
button can enable you to quit any function setting.
Maximum voltage set (>MAX VOLT)
The range of setting voltage is from 0V to rated voltage. You can press +
I-setI-set
(Menu) button to enter the menu, then press direction key to
select >MAX VOLT item. Press
Enter
button to confirm. After you set the