IT6900 User Manual
Copyright ©ITECH Electronics Co., Ltd. v
its protection may be damaged.
Always use dry cloth to clean the equipment housing. Do not clean the
inside of the instrument.
Do not block the air vent of the equipment.
Environmental conditions
The IT6900 series power supply can only be used indoors or in low
condensation areas. The following table shows general environmental
requirements for this instrument.
20% - 80% (non condensing)
Operating up to 2,000 meters
Note
To make accurate measurements, allow the instrument to warm up for 30 min before
operation.
Regulation tag
The CE mark indicates that the product
complies with all the relevant European
legal directives. The specific year (if any)
affixed refers to the year when the design
was approved.
The instrument complies with the WEEE
Directive (2002/96/EC) marking
requirement. This affixed product label
indicates that you must not discard the
electrical/electronic product in domestic
household waste.
To Next Page
Loading...
