Quick Start
Copyright ©ITECH Electronic Co., Ltd. 11
8. Analog control interface
The rear panel of IT6952B/IT6953B is shown in the next figure.
1. Cooling window
2. RS232 Communication cable interface
3. USB Communication cable interface
4. Output Sync signal interface and RS485 Communication cable
interface
5. GPIB Communication cable interface (IT6900(G) series only)
6. Analog control interface
7. Remote measurement terminal and DVM input terminal
Attention: The + and - terminals here are only used for shorting
between S+ and S-, not the output terminals, so do not connect to
the DUT.
8. Output terminal
9. Fuse
10. AC power socket
2.6 Power-on Self-test
A successful self-test indicates that the purchased power product meets
delivery standards and is available for normal usage.
Before operation, please confirm that you have fully understood the safety
instructions.
To avoid burning out, be sure to confirm that power voltage matches with
supply voltage.
Be sure to connect the main power socket to the power outlet of protective
grounding. Do not use terminal board without protective grounding. Before
operation, be sure that the power supply is well grounded.
To avoid burning out, pay attention to marks of positive and negative
polarities before wiring.
To Next Page
Loading...
