Function and Features
Copyright © Itech Electronics Co., Ltd. 27
Edit Recall Enable
3.10.2 List operation
With List operation applied to the alternating power supply, alternating
waveform sequences in various ranges may be output. The surge/trapped
wave may be added as required to simulate fluctuation of network voltage so as
to evaluate the test result of the instrument under such situation.
Various alternating sequences with output varied may be formed by listing the
voltage, frequency, slope, surge/trapped wave each step.
Surges wave
List sequences of IT7300 series can be stored into a non-volatile register,with a
capacity of 100 steps.The user can edit up to 10 files. Following shows how to
edit,recall and run a list file:
> Set Trigger Source
The surge/trapped wave test of LIST may be manually triggered to
control the start time of the surge/trapped wave.
Press (Shift)+ (Menu) to entry the menu. Then the system
will keep flickering------press to confirm.Press right key to select
Trigger.When selected,trigger item will be twinkling.Press to
confirm.Press right key to select Manual and press to confirm.
> Edit LIST File
1. Press (Shift)+ (List) button.
Off
0.0V 0.0mA 50.0
0.00W PF=0.000 0.0S
2.
select Edit,press to confirm.
LIST
Edit Recall Disable
3.
Press numeric key,set the step counts(range:1~100),press to
confirm.
STEP COUNT
Step Count=0
4. Press numeric key,set number of cycles(range:1~1000),press
to confirm.
LIST REPEAT
List Repeat=0
To Next Page
Loading...
