ITech IT7321 User Manual

Function and Features
Copyright © Itech Electronics Co., Ltd. 29
> Set LIST State
1. Press (Shift)+ (List) to entry the List menu.
Off
0.0V 0.0mA 50.0
0.00W PF=0.000 0.0S
2.
Press right key to select Disable,when it flicker,press up/down key to
select Enable,and press to confirm.
LIST
Edit Recall Disable
3.
Now the List mode is enabled.Escape menu,the front panel will
display “LIST 0”.
LIST
Edit Recall Enable
4.
List mode is enabled
Off
0.0V 0.0mA 50.0
0.00W PF=0.000 List 0
> Run LIST File
When LIST is in Enable status, exit menu.
 If List-Set under Config menu is set to On/Off: Press key to turn on
power supply output, and LIST file starts running. Press to stop
running.
 If List-Set under Config menu is set to Trigger: Press (Shift)+
(Trigger) key to trigger and the LIST file starts running. Press (Shift)+
(Trigger) again to stop running.
List running flag: When List is running, is flicking, and LIST step
displayed at the right bottom of VFD will also change by setting as time
elapses.
> Quit LIST Mode
1. Press (Shift)+ (List) to entry the List menu.
Off
0.0V 0.0mA 50.0
0.00W PF=0.000 0.0S
2.
Press right key to select Enable,when it flicker,press up/down key to
select Disable,and press to confirm. indicating List mode is
disabled.
LIST
Edit Recall Enable
3.
Press to quit the List menu.
LIST
Edit Recall Disable
> Recall LIST Mode
If several List files are edited, you can recall the Listfile to be tested by Recall.
When LIST is in Enable status, exit the menu to perform test.
1.
Press (Shift)+ (List)button to entry the List menu
8
Enter
8
Enter
8

ITech IT7321 Specifications

General

Brand	ITech
Model	IT7321
Category	Power Supply
Language	English