ITech IT8702 - Protection Functions; Over Voltage Protection (OVP); Over Current Protection (OCP)

IT873X Specific Commands
Copyright © Itech Electronic Co., Ltd. 51
:SAVe
:VOLTage
:POINt
[:LEVel]
:METEr
:POINt
[:LEVel]
:CURRent
:POINt
[:LEVel]
:METEr
:POINt
[:LEVel]
Save calibration param.
Set voltage calibration point (P1 to P4)
Enters a voltage value from extern meter
Calibrate voltage meter
Set voltage calibration point (P1 to P4)
Enters a voltage value from extern meter
Set current calibration point (P1 to P4)
Enters a current value from extern meter
Calibrate current meter
Set current calibration point (P1 to P4)
Enters a current value from extern meter
Remote Analog Control Command
Command
Description
Default
Value
SCPI
[SOURce:]INPut:CONTrol Remote analog control status - -