Error Information
Copyright © ITECH Electronic Co., Ltd. 65
(-225) Out of memory
(-230) Data Corrupt or Stale
(-270) Macro error
(–272) Macro execution error
(–273) Illegal macro label
(–276) Macro recursion error
(–277) Macro redefinition not allow
System errors from -300 to -399 (Set bit 3 of standard event register) are
explained as follows.
(-310) System error [generic]
(-350) Too many errors [errors beyond 9 lost due to queue overflow]
Query errors from -400 to -499 (Set Bit2 of standard event register) are explained
as follows.
(–499) (sets Standard Event Status Register bit #2)
(-400) Query error [generic]
(-410) Query INTERRUPTED [query followed by DAB or GET before
response complete]
(-420) Query UNTERMINATED [addressed to talk, incomplete programming
message received]
(-430) Query DEADLOCKED [too many queries in command string]
(-440) Query UNTERMINATED [after indefinite response]
Checking errors from 0 to 99 (Set bit 3 of standard event register) are explained as
follows.
0 No error
1 Module Initialization Lost
2 Mainframe Initialization Lost
3 Module Calibration Lost
4 Non-volatile RAM STATE section checksum failed
5 Non-volatile RAM RST section checksum failed
10 RAM selftest
11 CVDAC selftest 1
12 CVDAC selftest 2
13 CCDAC selftest 1
14 CCDAC selftest 2
15 CRDAC selftest 1
16 CRDAC selftest 2
20 Input Down
40 Flash write failed
41 Flash erase failed
80 Digital I/O selftest error
Equipment related errors from 100 to 32767 (Set bit 3 of standard event register)
are explained as follows.
213 RS-232 buffer overrun error
216 RS-232 receiver framing error
217 RS-232 receiver parity error
218 RS-232 receiver overrun error
To Next Page
Loading...
Need help?
General
