Error Information
Copyright © ITECH Electronic Co., Ltd. 66
220 Front panel uart overrun
221 Front panel uart framing
222 Front panel uart parity
223 Front panel buffer overrun
224 Front panel timeout
225 Front Crc Check error
226 Front Cmd Error
401 CAL switch prevents calibration
402 CAL password is incorrect
403 CAL not enabled
404 Computed readback cal constants are incorrect
405 Computed programming cal constants are incorrect
406 Incorrect sequence of calibration commands
407 CV or CC status is incorrect for this command
408 Output mode switch must be in NORMAL position
600 Lists inconsistent [lists have different list lengths]
601 Too many sweep points
602 Command only applies to RS-232 interface
603 FETCH of data that was not acquired
604 Measurement overrange
605 Command not allowed while list initiated
610 Corrupt update data
611 Not Updating
To Next Page
Loading...
Need help?
General
