4.9 Setting Absorption Charging Voltage and Duration
(Only adjustable on Usr1 battery charging profile)
Navigate to the Absorption Voltage screen (refer to figure 8), then press and hold
Button A for more than 3 seconds until the value starts to flash, then using
buttons A or B to increase or decrease the Absorption Voltage, once the desired
voltage is set, press, and hold Button A for more than 3 seconds to advance to
the duration setting, once again use Buttons A or B to adjust. Finally press and
hold Button A for more than 3 seconds to save all changes.
- 17 -
To Next Page
Loading...