Appendix K: Standard Operating Procedures
2465-623 User Manual Rev F Page 96
9. Spray the proper maintenance fluid, as identified below, onto a 5760832 Lint-Free
Swab.
9.1 For Printheads using VersaPrint ink, use FoxJet P/N 9001-0183-01 spray.
9.2 For Printheads using ScanTrue® II PLUS ink, use FoxJet P/N 5760695 spray.
10. Wipe the CP/OP with the dampened swab in a downward direction
.
11. Press and release the Purge button to initiate an automatic prime/purge cycle (observe
that the ink is vacuumed off the CP/OP).
12. Run a print sample to ensure all the channels are printing and producing good print
quality.
IF PRINT QUALITY IS ACCEPTABLE, PROCEED NO FURTHER
.
13. If there are any channels that still do not print, repeat steps 8 through 12 as required.
Replacing APS waste ink bottles
FoxJet APS systems have waste ink catch bottles installed to the rear of the printhead/ink
system and employ a waste ink detection circuit to disengage the APS feature when the bot-
tle becomes full. Failure to replace a full waste ink bottle will disengage the APS system.
To maximize equipment longevity and increase performance, preventive maintenance rou-
tines must be performed on pre-defined daily, weekly, and/or monthly schedules.
If performing these measures is not already a regular practice, it should be immediately es-
tablished as a top priority to prolong the life of the system.
FoxJet may deny warranty coverage if the printer or part has failed as a result of abuse, ne-
glect, improper maintenance, or unapproved modification(s). Please refer to the Master
Warranty Statement.
END
To Next Page
Loading...