Section 7: Maintenance and Shutdowns
2465-623 User Manual Rev F Page 69
Shutdown Procedures
• Close the Application (double-click the X in the upper right hand corner).
NOTE: You must have the proper security level before the application will close.
• When Windows® is at the desktop, select
Start, then select Turn Off Computer.
• Select
Turn Off Computer (Windows® will perform its shutdown sequence).
• When Windows® is done, the screen will be all white.
• It is now safe to turn the power off.
Shutdowns of 1 Week to 3 Months
• Disconnect the system from mains power.
• Spray the appropriate maintenance spray
on a lint-free cloth and, before installing
ship cap, lightly wipe the front of the print
head to remove foreign debris.
• Remove the ink bottle, close the reservoir
vent cap and install the reservoir ship cap.
• Install the ship cap onto the front of the
print head.
Shutdowns of 3 Months or More
• Follow recommendations for Shutdowns of 1 Week to 3 Months (above).
• It is recommended that the print head system be flushed with ScanTrue® II Flush Solu-
tion and that ScanTrue® II Flush Solution be left in the print head during the storage
period. (See “Appendix C: Part Numbers” on page 83 for consumable part numbers.)
Follow instructions in document 2465-257N. Flush Solution can remain in the print
head for one year from the date of flushing.
Startup
• Ensure all electrical connections are made and power up the controller.
• Allow the print head to heat up and perform a visual inspection on the heads before
using.
• Open the reservoir vent cap and install a bottle of ink.
• Perform 3 to 5 prime cycles while the Ship Cap is installed.
• Remove the Ship Cap.
• Prime the print head per “Step 5: Priming the Print Heads” on page 12.
To Next Page
Loading...