ITW Simco-Ion EA-5J - 5.4 Measurement condition setting

5.3 Initial screen
As POWER button blue is pressed, the sensor plate is()
grounded and automatic measurement mode Au is()
displayed as shown in the right figure. The measurement
mode can be changed by pressing MODE button white as()
shown in the figure below.
Initial display
()⇒ ()⇒ ()Auto mode Au PC Mode Pc Manual mode Ma
Mode display
5.4 Measurement condition setting
[]Measurement condition setting can be done in ion balance measurement mode ib
yellow and decay time measurement mode dE red /+ Decay or green /-() [](
Decay in the manual mode.)
Manual mode screen
Ion balance mode Positive Decay time Negative Decay time
screen mode screen mode screen
() ( ) (- )IB button +DECAY button DECAY button
-page14-