5.4.1 Measurement condition setting in ion balance measurement mode
When manual mode Ma is displayed, the measurement mode can be changed to()
ion balance mode ib by pressing the ion balance mode button IB yellow .() ( )
Auto mode PC mode Manual mode Ion balance mode
Flow of LCD display
Press SET button function switch by a thin stick 1 2 mm diameter . The() (～ )
three measurement condition can be set with the following procedure.(①～③)
After choosing by pressing UP/DOWN buttons, each setting is saved in the internal
memory by pressing SET button again. When all setting is complete, ion balance
measurement mode ib is displayed again. If MODE button white is pressed the() ( )
display will return to manual mode Ma .()
()How to press the measurement condition setting button SET
-page15-
To Next Page
Loading...