8
OPERATIONAL INSTRUCTIONS
USAGE
GENERAL OPERATION
1. Place the unit in the upright position ensuring that it is
on a flat, stable, heat-resistant surface.
Note: To avoid a hazardous condition, do NOT
place within 39 inches (100 mm) of anything that is
flammable or heat-sensitive.
2. Plug unit into wall socket (check the rating label to
ensure that it matches the voltage of your electrical
outlet).
3. Ensure that the Water Reservoir
4
is properly attached
and placed.
Note: If the Reservoir Full light illuminates on first use,
slide water reservoir out and make sure that “Float”
lever moves freely. Return reservoir to proper position.
USAGE
WHEN RESERVOIR FULL LIGHT IS ON
When the reservoir is full, the unit will stop and the
“Reservoir Full” light
A
will illuminate. Carefully
remove the reservoir from the unit by sliding it out
from the front of the unit, and discard water. Once
the reservoir is empty, return it to position. The unit
will return to normal operation.
Note: Use both hands when emptying the reservoir
to avoid spillage.
DEFROST MODE
When the unit operates at low temperatures (less
than 56.6°F/12°C, a layer of frost may develop on the
evaporator surface, which reduces the dehumidifier’s
eciency. In these cases, the unit goes into periodic
Defrost Mode. Time to defrost may vary.
Note: This unit can operate in temperatures as low as
41°F/5°C. If the unit freezes, turn OFF and restart. If the
room temperature remains below 41°F/5°C, switch the
unit OFF.
To Next Page
Loading...
Need help?
General
