Jabra Noise Guide - Import Data from USB;  ImportDataFromUsb;  MeasurementLibrary; Factory Settings

RETURN TO "TABLE OF CONTENTS" NOISE GUIDE – MANUAL
2424
NAVIGATING THE SOFTWARE
IMPORT DATA FROM USB
1. ConnectaUSB-keytoyourNoiseGuide.
Whilethedataisexportingfromtheinternallogtothe
USB-key,theEar-symbolwilllightyellow.Itmaytakeup
toafewminutes,dependingontheamountofdata.
2. RemovetheUSB-keyfromthedevicewhentheyellow
lighthasstoppedflashing.InserttheUSB-keyinyourPC.
3. Openthesoftwareandclick”ImportfromUSB”.
Thesoftwarewillopenthefolderautomatically.
4. Selectthefileyouwanttoimport.
5. Thesoftwarenowconvertstheear-filetoaCSV-format
andsavesthefileinthelibrary.
FACTORY SETTINGS
Ifyouwish,youcanalwaysrestoretheNoiseGuide'sFactorySettings.WerecommendthatyouinstalltheFactory
Settingswheneverthefirmwareisbeingupdated.YoucanalsorestoretheFactorySettingsifyouwanttoresetthe
internalmemoryinyourNoiseGuide.