Need help?Do you have a question about the JABSCO 31295 Series and is the answer not in the manual?
General| Series | 31295 |
|---|---|
| Type | Flexible Impeller |
| Rotation | Reversible |
| Voltage | 12V DC or 24V DC |
| Motor Type | Permanent Magnet |
Connect fittings using flexible hose and clamps to reduce vibration.
Install a strainer between the tank and pump inlet to protect valves from debris.
Fasten pump to a flat surface, pumphead down if mounting vertically.
Install inlet and discharge fittings and secure them with slide clips.
Wiring must comply with standards and include fuse/breaker to prevent fire.
Table specifies wire gauge based on pump voltage and total wire length.
Fill tank, open faucets, turn pump on, then close faucets nearest the pump.
Do not operate the pump continuously for more than 15 minutes.
Table lists pump models with voltage, amp draw, fuse size, flow, and pressure.
Diagram illustrating pump components for service and repair.
Lists part numbers for key components like pressure switches and pumpheads by series.
Details available snap-in port fittings for connecting hoses and pipes to the pump.
Drain the tank and plumbing, then purge pump head to prevent freeze damage.
Use non-toxic potable water antifreeze; avoid automotive types due to toxicity.
Leave all faucets open to protect plumbing from potential damage.
To Next Page
