JABSCO 31395-0092 User Manual

www.PumpAgents.com
MODEL VOLTS AMP DRAW (A)
@ 10 psi (0.7 bar)
FUSE SIZE (A) OPEN FLOW
GPM (l/min)
MAX PSI (bar)
31395-0092 12V dc 4.4 10 2.9 (11) 50 (3.4)
31395-0094 24V dc 2.2 5 2.9 (11) 50 (3.4)
31395-0392 12V dc 4.4 10 2.9 (11) 40 (2.7)
31395-0394 24V dc 2.2 5 2.9 (11) 40 (2.7)
31395-0292 12V dc 4.4 10 2.9 (11) 25 (1.7)
31395-0294 24V dc 2.2 5 2.9 (11) 25 (1.7)
31295-0092 12V dc 3.5 10 1.9 (7) 25 (1.7)
31295-0094 24V dc 1.7 5 1.9 (7) 25 (1.7)
3.18
(80 mm)
4.24
(105 mm)
4.75
(121 mm)
9.00
(229 mm)
3.12
(80 mm)
2.25
(63 mm)
31295 / 31395 - SERIES
AUTOMATIC WATER SYSTEM PUMP
31295 / 31395 - Series
Pump Series Dimensions - Inches (mm) Weight
Height Width Length lb. (kg)
31X95-XXXX 4-3/4" (121) 6" (152) 9" (229) 3.5 (1.6 kg)
With pump switch off and battery fully charged, fill water tank,
open all faucets, then turn pump switch on. Water will begin to
flow. When the water is free of air, turn faucets off. Remember,
you are filling the water heater and the toilet and shower lines.
When all valves are shut-off, pump will stop. Should pump fail to
stop, turn switch off and see the trouble shooting guide.
OPERATION
DIMENSIONAL DRAWING
(2) 1/2” (13 mm) Hose Barbs
FEATURES
• Smooth Flow
• Self-Priming up to 10 feet (3m)
• Dry running capability
• Soft noise absorbing mounts
• Snap-fit port fittings
• Built-in bypass — less pulsation
• Reduces need for accumulator tank
• Corrosion resistant materials
• Thermal overload protection
• Motor rating: IP 54
• CSA listed
• ISO 8846 MARINE (ignition protection)
•
SPECIFICATIONS
Motor: Permanent Magnet, Ball Bearing Totally Enclosed.
Not for Continuous Duty. Intermittent Duty Only.
Pump: Body - Polypropylene
Diaphragm - Santoprene
Valves - EPDM
Fittings: (2) 1/2” - 14 Male pipe
PumpAgents.com - buy pumps and parts online
PumpAgents.com - Click here for Pricing/Ordering

JABSCO 31395-0092 Specifications

General

Model Number	31395-0092
Category	Water Pump
Type	Diaphragm
Voltage	12V DC
Shaft Seal	Lip Seal
Self-Priming	Yes
Motor	Permanent Magnet
Fuse Size	15A
Pressure	30 PSI
Port Size	3/4"

Summary

Pump Specifications and Operation

Pump Specifications

Details on motor, pump materials, and fittings for the water system pump series.

Pump Operation Instructions

Guidance on starting, running, and shutting down the automatic water system pump.

Installation and Wiring Guide

Pump Installation Steps

Instructions for mounting the pump horizontally or vertically, connecting ports, and using mounts.

Electrical Wiring Procedure

Guidance on connecting the pump to the power supply, including wire gauge recommendations.

Service Parts and Maintenance

Automatic Water System Pump Service Parts

List of available replacement parts for the pump series, including pressure switches and pumpheads.

Winterizing Procedures

Steps to prepare the pump and system for freezing temperatures to prevent damage.

Sanitizing and Troubleshooting

Sanitizing Potable Water Systems

Procedure for disinfecting the water system using bleach solution.

Troubleshooting Common Issues

Solutions for problems like pulsating flow, failure to prime, and motor not turning on.