JABSCO 36600-0000 User Manual

ELECTRIC BILGE PUMPS
FEATURES
• Self-Priming
• Diaphragm Design Allows Dry Running
•Quiet Operation
• Built-in Hydraulic Pulsation Dampener
• Permanently Lubricated Ball Bearings on Shaft
and Connecting Rod
• Large Vibration Absorbing Pads
• Corrosion Resistant Materials Throughout for
Sea Water Service
• Meets USCG Regulation 183.410 and
ISO 8846 MARINE for Ignition Protection
SPECIFICATIONS
Open Flow: 8.0 GPM
Vert. Dry Suction Lift: 10 feet (3 m)
Ports: 3/4" Slip-on Hose
Weight: 11 lb
APPLICATION
Jabsco diaphragm bilge pumps are self-priming, so they
can be mounted above and outside of harsh bilge envi-
ronments. Because they are mounted remotely, the
intake hose can be routed to the lowest point of the bilge
regardless of space limitations. They are supplied with
an in-line strainer to prevent damaging debris from
entering pump. The reliable diaphragm design is not
damaged by dry running.
INSTALLATION
MOUNTING
Mount upright in a dry location (above highest bilge
water level) on a solid surface. Adjust belt tension for
1/4" play between pulleys.
PLUMBING
For intake and discharge use 3/4" ID non-collapsible
hose. Keep intake and discharge lines free of kinks and
restrictions. Use the 3/4" bilge in-line stainer (Model
36200-0000) in the intake line from the bilge to protect
pump from debris. Use a 3/4" thru-hull fitting for dis-
charge.
WIRING FOR DC VOLTAGE MODELS:
Wire pump in a circuit independent of all other electrical
fixtures. Use stranded copper wire. Install fuse/breaker
in positive circuit. See table for recommended wire and
fuse size. See diagram for wiring connections. Use a 10
amp-rated switch 44960-0000. After installation, it is rec-
ommended that voltage be checked at the motor termi-
nals with motor operating under full load and all other
appliances in the circuit operating. Voltage should not be
less than 90% of rated motor voltage.
STANDARD MODELS
Amperage
Model Voltage Nominal
36600-0000 12 Vdc 11.0
36600-0010 24 Vdc 5.5
36600-0031 115 Vac 1.0
Model 36600-Series
Model 36600-Series

JABSCO 36600-0000 Specifications

General

Model Number	36600-0000
Voltage	12 VDC
Self-Priming	Yes
Housing Material	Polypropylene
Type	Water Pump
Fuse Size	15 Amp
Port Size	3/8" Hose Barb

Summary

Electric Bilge Pumps

Pump Application

Describes how Jabsco diaphragm bilge pumps are self-priming and can be mounted remotely.

Pump Installation

Provides guidance on mounting and plumbing for bilge pumps.

Mounting Instructions

Mount pump upright in a dry location on a solid surface. Adjust belt tension.

Plumbing Guidelines

Use 3/4" ID hose for intake/discharge, keep lines free of kinks, use strainer.

Standard Pump Models

Lists standard Jabsco bilge pump models with voltage and amperage.

DC Voltage Model Wiring

Instructions for wiring DC bilge pumps independently with proper wire and fuse size.

Electrical Specifications and Wiring

Electrical Specifications

Details wire size for length of run and fuse/breaker requirements for different models.

AC Voltage Model Wiring

Specifies wiring procedures for AC voltage bilge pump models.

Maintenance and Storage

Covers general maintenance and specific guidelines for winter storage.

Troubleshooting

Lists common problems like loss of suction or rough operation and their causes.

Service Procedures

Provides instructions for replacing diaphragm, rod, valves, and pulsation dampeners.

Parts and Dimensions

Exploded View and Parts List

Details components of the 36600-Series pump with part numbers.

Marine Switch Panels

Information on lighted and unlighted SPDT switches for bilge pumps.

Automatic Bilge Pump Switch

Details the RS-20 automatic float switch for bilge pump operation.

Dimensional Drawing

Provides overall dimensions and mounting hole details for the pump.

Float Switch Cover

Information on float switch covers for DC applications.

Warranty Information

Limited Warranty

States JABSCO's warranty for products regarding material and workmanship.

Warranty Adjustment

Outlines the process for obtaining repair or replacement for defective products.

Exclusions and Liability Limitations

Lists conditions that void the warranty and limits JABSCO's liability.

Consumer Rights

Explains specific legal rights granted to consumers by the warranty.