CONTROLS 4
en-39
4.2.6.37 WEIGHT TRANSFER _____________________________________________________
Navigate to the PIN Menu. See 4.2.6.16
Use the UP and DOWN arrow keys until the green arrow is
next to Weight Transfer Pressure. Press the select button to select Weight
Transfer Pressure.
Press the select button to disable or enable the weight transfer pressure.
Press the back button to return to previous menu.
4.2.6.38 AWD IN REVERSE _______________________________________________________
Navigate to the PIN Menu. See 4.2.6.16
Use the UP and DOWN arrow keys until the green arrow is
next to AWD in Mow. Press the select button to select AWD in Mow.
Press the select button to disable or enable the AWD in Mow function.
Press the back button to return to previous menu.
When AWD in Mow is enabled, the AWD solenoid will be engaged when the
mow switch is enabled and pedal not in reverse. In AWD mode, the maximum
theoretical traction speed obtainable is 6mph.
When AWD in Mow is disabled, the AWD solenoid will not be engaged when
the mow switch is enabled. This allows the operator to mow in 2WD mode,
where the 7mph mow speed limit is obtainable.
Change PIN
Inclinometer
Set Default Parameters
Fan Drive
Weight Transfer Pressure
Reset Service Hours
PIN Menu
Disable
Enable
Weight Transfer Pressure
One Touch
AWD in Mow
Vehicle Speed
Change PIN
TST
Set Default Parameters
PIN Menu
To Next Page
Loading...
