en-39
CONTROLS 5
5.6 WARNING SCREENS____________________________________________________
When a fault, warning or hazard presents itself, the following screens are displayed.
5.6.1 SLOPE ANGLE DISPLAY
_______________________________________________
During work, if the machine is driven on a slope of 16° the machine angle
will be displayed in the centre of the screen, until the machine has been
driven onto an area of less than 16°.
Note: Whilst in Transport Mode, the TST icon on screen will appear Red
with Cross, indicating TST is disabled.
CAUTION
While in Transport Mode the following audible alarms are disabled for TST™ functions:
Maximum Slope Angle Exceeded, Inhibit Cut and Stop Cut
!
To Next Page
Loading...