Jacobsen JMP653F - Emission Fault - Egr Nox Control; Emission Fault - Maf Sensor; Emission Fault - Dpf Sensor; Clean Dpf Ash

en-43
CONTROLS 5
5.6.12 EMISSION FAULT – EGR NOX CONTROL _______________________________
When this screen is shown, the engine controller (ECU) is reporting a fault
with EGR system or sensor.
The output from the engine will be reduced.
Stop the engine as soon as possible and contact your local Jacobsen
Dealer.
5.6.13 EMISSION FAULT – MAF SENSOR ___________________________________
When this screen is shown, the engine controller (ECU) is reporting a fault
with the MAF (Mass Air Flow) sensor. The output from the engine will be
reduced. Stop the engine as soon as possible and contact your local Jacob-
sen Dealer.
5.6.14 EMISSION FAULT – DPF SENSOR ____________________________________
When this screen is shown, the engine controller (ECU) is reporting a fault
with the DPF (Diesel Particulate Filter). Stop the engine as soon as possi-
ble and contact your local Jacobsen Dealer.
5.6.15 CLEAN DPF ASH __________________________________________________
When this screen is shown, the engine controller (ECU) is reporting that
the level of ash in the DPF (Diesel Particulate Filter) is in excess of 95%
and therefore the DPF needs to be serviced. Contact your local Jacobsen
Dealer for information on the procedure for servicing the DPF.
1/1
EGR
NOx
1/1
MAF
SENSOR
1/1
DPF
SENSOR
1/1
>95%