To Next PageTo Next Page
Why do my Jacobsen Lawn Mowers not cut or cut unevenly?
If the Jacobsen Lawn Mower mowers do not cut or cut unevenly: * Ensure the cutting units are fully lowered to the ground. * Check the engine speed and run the engine at full throttle if it’s too low. * Check the hydraulic oil reservoir level and fill if needed.
Why won't my Jacobsen Lawn Mower engine start?
If your Jacobsen Lawn Mower's engine won't start, there are several potential causes: * The parking brake might be disengaged, the traction pedal might not be in neutral, or the PTO switch might be on. Ensure the interlock system is properly set and follow the correct start-up procedure. * The battery could be low on charge or defective. Inspect the battery's condition and its connections. * The fuel tank might be empty or contain dirty fuel, or the fuel shut-off valve could be closed. Refill the tank with fresh fuel, change the fuel filter, bleed the fuel lines, and open the fuel shut-off valve. * A circuit breaker might have blown. Try resetting the circuit breaker.
What to do if my Jacobsen R-311T engine stops?
If your Jacobsen Lawn Mower engine stops, it could be due to: * An empty fuel tank. Refill with fresh fuel and bleed the fuel lines. * Interlocks not being set before you leave the operator’s seat. Engage the parking brake, set the reel switch to OFF, and put the traction pedal in Neutral.
Why is the battery on my Jacobsen R-311T Lawn Mower not holding charge?
If your Jacobsen Lawn Mower's battery isn't holding a charge, here are a few things to check: * Inspect the battery terminals for looseness or corrosion and clean them. * Check the electrolyte level and refill to the correct level if it's low. * See if the alternator belt is loose or broken, and tighten or replace it if necessary. If the charging system is defective, consult the engine manual.
Why is my Jacobsen R-311T Lawn Mower engine hard to start or running poorly?
If the Jacobsen Lawn Mower engine is hard to start or running poorly, consider these possibilities: * The fuel level might be low, or the fuel/fuel filter could be dirty. Refill with fresh fuel, change the fuel filter and bleed the fuel lines. * The air cleaner might be dirty. Inspect and replace the air filter. For issues related to the injectors or fuel pump, or for general engine problems, consult the engine manual.
What to do if my Jacobsen R-311T engine keeps stopping?
If your Jacobsen Lawn Mower engine stops, first ensure the fuel tank isn't empty, and if it is, fill it with fresh fuel and bleed the fuel lines. Also, make sure all interlocks are properly set before you leave the operator’s seat by engaging the parking brake, setting the reel switch to OFF, and placing the traction pedal in Neutral.
Why is my Jacobsen Lawn Mower engine hard to start?
If your Jacobsen Lawn Mower engine is hard to start or runs poorly, begin by checking the fuel level and ensuring the fuel and fuel filter are clean; replenish with fresh fuel, change the fuel filter, and bleed the fuel lines. Also, inspect and replace the air filter if it's dirty. For issues with the injectors or fuel pump, consult the engine manual.
How to fix Jacobsen Lawn Mower engine that is hard to start?
If your Jacobsen Lawn Mower engine is hard to start or runs poorly, begin by ensuring the fuel level is adequate and the fuel or fuel filter isn't dirty; fill with fresh fuel, change the fuel filter, and bleed the fuel lines. Next, inspect and replace the air filter if it's dirty. For issues with the injectors or fuel pump, or if it's an engine problem, consult the engine manual.
What to do if my Jacobsen Lawn Mower engine is overheating?
If your Jacobsen Lawn Mower engine is overheating, start by checking the coolant level and adding coolant if needed. Then, clean the cooling air intake to ensure it's not restricted. Inspect the water pump belt for looseness or breakage, tightening or replacing it as necessary. Lastly, reduce the forward speed to avoid engine overload.
Why is my Jacobsen R-311T Lawn Mower engine overheating?
If your Jacobsen Lawn Mower engine is overheating, here's what could be happening: 1. The coolant level may be low. Check the coolant level and add more if needed. 2. The air intake might be restricted. Clean the cooling air intake. 3. The water pump belt could be broken or loose. Tighten or replace the belt. 4. The engine may be overloaded. Reduce your forward speed.
General| Cutting Width | 21 in |
|---|---|
| Weight | Not available |
| Fuel Type | Gasoline |
| Engine Type | Kohler CH740 |
| Drive Type | Hydrostatic |
| Height of Cut | 1.5 to 5 inches |
| Engine | Kohler CH740 |
| Transmission | Hydrostatic |
| Cutting Height Range | 1.5 to 5 inches |
Essential safety guidelines for operating the mower.
Key safety alerts, warnings, and hazard symbol explanations.
Identification and explanation of critical safety and operational decals and alerts on the machine.
Explains the meaning of various symbols used for mower controls.
Identifies and describes individual controls by letter and name.
Details the function of specific control levers on the panel.
Explains the operation of various switches on the control panel.
Describes gauges, warning lights, and circuit breakers for system monitoring.
Details machine system monitoring alerts and required actions for each warning light.
Outlines daily checks and the safety interlock system functionality.
Provides general guidelines for safe machine operation and handling.
Details the procedures for starting, stopping, and parking the engine and mower.
Covers transport latches, driving, and safe operation on slopes.
Explains mowing techniques, ROPS folding, towing, and daily maintenance tasks.
Guidance on performing test cuts and verifying mower performance.
Explains washboarding and step cutting, their causes and remedies.
Describes scalping and stragglers, their causes and remedies.
Explains streaks, windrowing, and mismatched units and their causes/remedies.
Contains general notes or remarks not fitting other categories.
