J-200
9.0 Control Functions
9.1 Control Panel
A. Menu (
) Button: Allows access
to the programming menus.
B. LCD Display: Can display current wa-
ter temperature (default display), water
temperature set point, selected menu functions, and error messages.
Displays a CLEARRAY icon ( ) and heat icon ( ) when
those features are on.
C. Warmer Button (
): Increases water temperature set point.
Increments of 1°F or 0.5°C.
D. Cooler Button (
): Decreases water temperature set point.
Increments of 1°F or 0.5°C.
E. Jets 1 Button (
1
): Turns jets pump #1 on and off. Press once for
low speed; press a second time for high speed; press a third time to
turn pump off.
F. Jets 2 Button (
2
): Turns high-speed jets pump #2 on and off.
Press once to turn pump #2 on; press a second time to turn pump #2
off.
G. Light Button (
): Turns underwater light (if equipped) and accent
lights (if equipped) on in one of three random modes or one of seven
solid colors. Refer to Section 10.3 (page 27) for details.
Operation Details
• Temperature Adjustment: 65 to 104°F (18 to 40°C). Factory default
setting is 100°F (38°C).
• LED light system: All LED lights run for 2 hour and then automatically
shut off.
• Jets 1/Jets 2 Button Operation: Jets run for 20 minutes when
activated, then turn off automatically to conserve energy. Simply
press either jets button to continue operation for an additional 20
minutes.
1
2
B
A
E
C
D
F
G
2-pump control panel shown
23
To Next Page
Loading...
Need help?
General
