Jacuzzi J-200 Series Owner's Manual

J-200
10.5 Selecting Desired Massage Action
For models that incorporate a massage selector valve
(Diverter Jet for J-210, Figure A) that allows you to
customize the massage and performance by diverting
water between various jet systems within the spa. Simply
turn valve to positions A, B or C to divert water pressure
to various jet groups.
Note: The valve is intended to operate in positions A
(Combo), B, or C for optimum performance. It is consid-
ered normal for sound levels within the valve to increase be-
tween these positions due to the large amounts of water owing through
it. For optimum ltration benets, always leave this valve in position A
when the spa is covered and select positions B or C for maximum jet per-
formance during spa use.
10.6 Air Controls
Certain jet systems have their own air control. Each control
introduces air into the water lines that supply that specic jet group.
Simply turn the air control of choice counterclockwise to open or
clockwise to close.
Note: To minimize heat loss, all air controls should be closed when the
spa is not in use. Certain jets may not draw air when jets pump 1 is
running in low speed; this is considered normal.
10.7 Optional BLUEWAVE® Spa Stereo System (J-215
to J-280)
Spas equipped with the optional Jacuzzi audio system offer
enhanced enjoyment. These models include a high-quality
AUX/Bluetooth stereo receiver with four high-quality marine
speakers for unsurpassed sound quality and long-life.
Note: All operations for the BLUEWAVE system are
controlled via a connected Bluetooth or Auxiliary device.
10.8 Blow-Out Cycle
This cycle will purge the air from the plumbing lines normally caused by
draining and lling the spa. The Jets Pump 1 (low speed) will turn on for
1 minute and then shut off. Then Jets Pump 2 (if equipped) will turn on
and run for 1 minute then shut off. This cycle will only occur at start up.
Note: Turning off the corresponding jets pump that is running can
deactivate the feature.
10.9 Cleanup Cycle
The cleanup cycle occurs once per day at 12:00 PM (noon) for 2
minutes. This is not user programmable. The Jets Pump 1 (low speed)
will turn on for one minute and then shut off. Then Jets Pump 2 (if
equipped) will turn on and run for 1 minute then shut off.
Note: Turning off the corresponding jets pump that is running can
deactivate the feature.
B
A
C
B C
A
Figure A
28

Jacuzzi J-200 Series Specifications

General

Brand	Jacuzzi
Model	J-200 Series
Category	Hot Tub
Language	English