39
J-300
12.0 Spa Maintenance
Proper and regular maintenance of your spa will help it retain its beauty
and performance. Your authorized Jacuzzi dealer can supply you with
all the information, supplies, and accessory products you will need to
accomplish this.
DANGER: RISK OF SEVERE INJURY OR DROWNING BY
ENTRAPMENT!
• Keep hair, loose articles of clothing or hanging jewelry away
from suction ttings, rotating jets or other moving components
to avoid entrapment that could lead to drowning or severe
injury.
• Never use the spa unless all suction guards, lter, lter lid, or
skimmer assembly are installed to prevent body and/or hair
entrapment.
• Never operate or use the spa if the lter, lter lid, or skimmer
assembly are broken or any part of the skimmer assembly is
missing. Please contact your dealer or nearest service center
for service.
• The suction ttings and suction covers in this spa are sized
to match the specic water ow created by the pump(s). If it
is necessary to replace the suction ttings, suction covers or
pump(s), be sure that the ow rates are compatible and are in
compliance with the VGB Safety Act, page 2.
• Never replace a suction tting or suction cover with one rated
less than the ow rate marked on the original suction tting.
Using improper suction ttings or suction covers can create
a body or hair suction entrapment hazard that may lead to
drowning or severe injury.
• Owners must alert all spa users to the potential risk of Hair,
Limb, Body, Evisceration (disembowelment), and Mechanical
Entrapment, page 6.
!
12.1 Cleaning The Filters
Your Jacuzzi spa is equipped with a skimmer bag and two high
performance pleated lter cartridges located under the lter cover. The
circulation pump drawing water through the skimmer bag and lter
cartridge lters ne debris. Large debris is ltered by jets pump 1 drawing
water through the skimmer bag and second lter cartridge during an
automated Secondary Filtration Cycle or when jets pump 1 is manually
activated during spa use. Combined, both lters provide unsurpassed
water quality by trapping surface oils and suspended particles. The lter
cartridge should be cleaned once a month or as necessary, depending
on use, for optimum performance.
To Next Page
Loading...
Need help?
General
