EasyManuals Logo

Jacuzzi J-385 User Manual

Jacuzzi J-385
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #61 background imageLoading...
Page #61 background image
55
J-300
15.4 Poor Jet Action
Make sure all jets are in the full open “on” position (page 30).
Press the JETS 1 button to make certain pump #1 is on.
Verify all air controls are in the “on” position by pressing down on
their Jacuzzi Logo (page 31).
Check for dirty lter. Clean, if necessary (Section 12.1, page 39).
15.5 Water is Too Hot
Reduce thermostat setting.
15.6 No Heat
1. Check thermostat setting.
2. Keep the spa cover in place while heating.
3. Check the settings to see if your spa is in economy mode (page 34).
Should checking the above steps fail to correct the problem, please call
your Jacuzzi Hot Tub dealer so that they may arrange service. We build
the best spas in the industry. Nonetheless, we are always striving to
improve the quality and features of our products.
Your input as a Jacuzzi spa owner is a cherished part of this process. If
you have any comments or suggestions, or if you wish to be informed on
any new products for your spa, please write to us.
CONGRATULATIONS on your good taste and welcome to the happiest
and most relaxed family in the world!

Table of Contents

Other manuals for Jacuzzi J-385

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jacuzzi J-385 and is the answer not in the manual?

Jacuzzi J-385 Specifications

General IconGeneral
Seating Capacity6-7 Adults
Pumps2
Circulation PumpYes
Primary Pump2.5 HP
Secondary Pump2.5 HP continuous duty, 4.8 HP breakdown torque
Electrical Requirements240V

Related product manuals