Jacuzzi J-385 - Page 47

41
J-300
E
Lift unthreaded lter
cartridge from skimmer
well.
F
If used, remove the
chemical feeder as
instructed prior to rinsing
the lter cartridges.
Rinse debris from lter
pleats on each cartridge
using a garden hose and
high pressure nozzle.
Start at the top and
work downward towards
handle. Repeat until all
pleats are clean.
G
Trapped
Air
Bubbles
Cartridge 1
Cartridge 2
Submerge both lter
cartridges in spa. Tilt
threaded end upward
to remove trapped air
bubbles, then keep
cartridges submerged to
prevent air entrapment
during installation (step
H).
H
Place each cartridge
back into skimmer
well, then rotated
each cartridge handle
clockwise to thread back
into wall tting. DO NOT
OVERTIGHTEN!
I
(Filter Cover Back View)
Install clean skimmer
bag back onto the lter
cover clips as shown.
J
Tilt lter cover back then
gently press down to
latch against retaining
clips. Turn power to spa
back on.